Home / Plumbing Services / Faucets and Fixtures

Faucets and Fixtures

A dripping faucet is more than a nuisance. It’s often a worn cartridge or valve seat that’s easy to fix once it’s diagnosed correctly. Most modern kitchen and bathroom faucets are rated between 1.5 and 1.8 gallons per minute (GPM) under federal water-efficiency standards, a spec every replacement fixture we install has to meet.

Reliable Faucet and Fixture Services

Faucets, showerheads, and fixtures take more daily use than almost anything else in a home’s plumbing system, and it shows. We repair and replace kitchen faucets, bathroom faucets, shower valves, tub spouts, and outdoor hose bibs across Ontario, Fontana, Rancho Cucamonga, Riverside, and Eastvale. Federal water-efficiency standards cap most bathroom faucets at 1.5 GPM and kitchen faucets at 1.8 GPM (Source: EPA WaterSense, 2023). For the rest of our everyday plumbing lineup, see our full plumbing services page.
Common problems

Common Faucet and Fixture Problems

A dripping faucet is almost always caused by a worn washer, cartridge, or O-ring inside the fixture, letting water seep past a seal that used to hold tight. Low water pressure at a single faucet often points to a clogged aerator or a failing cartridge rather than a home-wide pressure problem.
Corroded or outdated fixtures, especially in older bathrooms across the Inland Empire, tend to develop mineral buildup, stiff handles, or valves that no longer shut off cleanly. Outdoor hose bibs are another common trouble spot, particularly ones that were never properly insulated and cracked during a cold snap.
Brands & types

Common Brands and Types We Work With

We install and repair a wide range of faucet and fixture brands and styles, from standard two-handle kitchen faucets to single-handle pull-down models, widespread bathroom faucet sets, and pressure-balanced shower valves.
Whether a home has a builder-grade fixture from years back or a homeowner is upgrading to a specific style or finish, our team sources parts and replacement units that match the existing plumbing rough-in whenever possible, which keeps the job simpler and faster.
Repair or replace

Repair vs. Full Replacement

Repair

Replacement

Good to know

Frequently Asked Questions

A dripping faucet is almost always an internal seal problem, a worn washer, cartridge, or O-ring, rather than something that tightening the handle can fix. Once the specific part is diagnosed, replacing it usually stops the drip completely.
Most standard faucet replacements are completed in under an hour once the new fixture is on-site, assuming the existing supply lines and rough-in match the new unit. More involved fixture upgrades, like a full shower valve replacement, take longer.
In many cases, yes. We source parts and replacement fixtures that match existing finishes and rough-in configurations whenever possible, and we’ll let you know upfront if an exact match isn’t available for an older or discontinued model.
Usually. A leaking hose bib is often a worn washer or a cracked fitting, especially if it was exposed to a cold snap without proper insulation. Replacement is straightforward in most cases and helps prevent the same crack from happening again.
Yes. We install a range of fixtures that meet current federal water-efficiency flow rate standards while still performing well, and we can talk through options if reducing water use is a priority.
Generally yes, since a shower valve often sits inside the wall and may require opening a small access point to reach it. We’ll walk you through what’s involved before starting.

Get Your Faucets and Fixtures Fixed Right

Whether it’s one dripping faucet or a full bathroom fixture upgrade, our team gives you an honest, written quote before any work begins. Request a quote today and we’ll follow up the same day to schedule a visit anywhere across the Inland Empire.